Brainboxes PX-246 Bedienungsanleitung PDF herunterladen (Seite 18)

Operation - System

5.1.1 CONFIG

Clicking the CONFIG button on the System page allows configuration of the application options.

This allows configuration of the display parameters and selection of the alarm sounds.

5.1.2 RUNNING EDITOR

Clicking the mouse with the right mouse button in the vicinity of the generator or mains icons on the System

page will open the generator ‘Running Editor’.

Changes made with the Running Editor take place immediately and the value is changed. There is no need to

‘save’ the changes. These parameters are also changed from the module fascia, DSE Config Suite SCADA

section and by Modbus RTU command from a suitably configured Master device.

Parameter Description

Generator Priority Generator Run Priority for the ‘Load Demand’ scheme

Select Mode Select between:

Bus/Gen Mode: Upon loading of the bus/generators in parallel with a

mains supply, places them into fixed export.

Mains Mode: Upon loading of the bus/generators in parallel with a mains

supply, places them into a peak lopping/shaving application.

Parallel Power (Min) This is the ‘bottom’ of the load ramp. When the generator joins the bus, it

will ramp up from this setting after closing the breaker.

When the generator leaves the bus, it will ramp down to this setting before

opening the breaker.

Parallel Power (Max) The power level to be produced by the generator when in ‘mains parallel

mode’ (fixed export mode).

Parallel Power Factor The power factor to be supplied by the generator when in ‘mains parallel

mode’ (fixed export mode).

If enabled, then the clocks of all

attached modules will be

immediately synchronised with the

local PC clock and then once a day

thereafter.

DSE8610 / DSE8710 / DSE8810

DSE8620 / DSE8660 / DSE8760

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Keine Kommentare

Brainboxes PX-246 Bedienungsanleitung Seite 18