
Operation - System
17
5 USING THE SCADA SUITE
To run the SCADA Suite Software program click the Windows start button
or depending upon your version of Windows.
Then select ‘All Programs’ - ‘Deep Sea Electronics PLC’ – “DSE SCADA Suite”
After a short delay to load the application, the main display is shown. The layout of this screen is application
dependant and shows a representative diagram of the system.
5.1 SYSTEM
The image below shows an example with three DSE8610’s, one DSE8660’s and one DSE8680 controller.
Clicking with the left mouse button in the vicinity of the generator or mains icons will change the display to
show the relevant control and instrumentation page.
Clicking with the right mouse button in the vicinity of the generator or mains icons will open the generator
‘Running Editor’.
Clicking the CONFIG button allows configuration of the application options.
The colour of the generator / mains symbols change dependant upon level of the alarm.
Grey Controller is offline (no communication)
Light Blue Controller is online (communicating) in STANDBY Any mode
Green
Controller is started/active or Engine/Generator is RUNNING Any
mode
Yellow Controller has a WARNING alarm present
Red Controller has a SHUTDOWN or electrical trip alarm present
This button enables the user
to browse and load different
SCADA configuration files.
Kommentare zu diesen Handbüchern