Brainboxes ES-701 Handbuch PDF herunterladen (Seite 8)

1. Connect the ES device to your local network or a private network by

using a standard straight-through or crossover Ethernet cable and

plugging into the Ethernet port connection.

2. Connecting to Power

Connect the power adapter or a DC power line (5-30V)

to the ES power terminal block or jack connection

If using the Brainboxes PW-644 power supply ensure:

a. The wire marked “-“ is connected to V-

b. The wire marked “+” is connected to V+

*If using your own power supply please check input requirements on page 4 - Hardware

3. Confirm the device beeps as it is turned on.

4. When the Status LED starts blinking green (after 5-60

seconds), the device is ready to use.

5. Connect the serial cable from your serial device to the serial port on

the ES device. Refer to Section 8 of this Quick Start Guide for pin

outs.

Make a note of device MAC address (on side panel, 00-0a-4f-XX-XX-XX) as

you will need it to identify the device on your network later.

4. Connecting your ES Device

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Keine Kommentare

Brainboxes ES-701 Handbuch Seite 8